EKPM Upgraded Board Configuration and Firmware

Downloads

6/28/2024 - Version 3.5 - Firmware V114 [Download] - Latest

Changes

  • Improves pump triggering speed on N54/N55 E-Series.
  • Changes to allow configuring module with "No Canbus" type selected.
  • Added ability to detect module in bootload mode for clarity.
  • Other small fixes.

11/18/2023 - Version 3.4 - Firmware V113 [Old Download] - Old Version

Changes

  • Corrects issue cause by JB4 diagnostic commands.
  • Installer now checks for VS2015 C++ prior to installing.
  • Installer now checks for .NET 4.7.2 or greater prior to installing.

7/18/2023 - Version 3.3 - Firmware V112

Changes

  • Corrects potential issue where a EKPM board could interrupt a MHD flash
  • Changes default trigger source to Engine Torque for Grounded Output and Second Relay.
    • With default settings, Grounded Output now triggers when engine torque is greater than 200 nm
    • With default settings, Second Relay now triggers when engine torque is greater than 200 nm

5/31/2023 - Version 3.0 - Firmware V109

Changes

  • Correct issues with N55 EWG support
  • Adds pump status logging PIDs for MHD (Beta)
  • Corrects canbus driver for max throughput
  • Corrects clicking issue due to overly strict canbus timeouts.

5/31/2023 - Version 2.3 - Firmware V108

Changes

  • Correct potential bug with main pump trigger.

4/30/2023 - Version 2.2 - Firmware V107

Changes

  • Adds config option to switch canbus type to N55 EWG. This N55 EWG support is in beta.
  • Adds support for N55 PWG
  • Simplifies settings.
  • New trigger source added "Trigger as Main Pump". This allows you to set any of the pumps as a main Pump

3/30/2023 - Version 2.1 - Firmware V105

Changes

  • Improve prime process. Prime now happens when the car wakes up(unlocking car)
  • Corrects a bug causing the relay to click on and off with ignition on engine off.

3/17/2023 - Version 2.0 - Firmware V104

REMOVE OLD VERSION FIRST
Changes
  • Adds support for Orange MHD WiFi Adapter.

Instructions

  1. Extract all of the files and run setup exe.
  2. Run "EKPM Upgrade Config Tool" found on the desktop or in the programs list.
  3. Once you have opened the tool, select "identify EKPM" this may fail on older firmware versions, that's okay.
  4. Next you will update the firmware by selecting "load firmware".
  5. Lastly select the latest version and select "flash firmware".
For immediate assistance reach out via text at (971) 717-2411‬ or via Facebook Messenger at Speedsy Motorsports | Facebook