Manual to Auto P/N Wiring - E9X/E60/E82

Did you switch from a manual chassis to auto trans after LS swapping? You usually need to run a P/N wire from the CAS->ECU to get the engine to start. Not anymore!

This product allows you to plug in two components to wire the park/neutral (P/N) wire to the stock location. This product lets you skip getting on your back to run a wire under the dash.

This product was designed for Speedsty Motorsports Plug and Play harness however, it can be used without it.

Comes with clutch wire loop and X6031 jumper wire.

Instructions:

1. Connect clutch wire loop to unused clutch switch connector. This makes X60001 pin 18 the P/N wire.
   
2. Connect jumper wire for plug and play harness. This wire connects X60001 to the P/N pin on X6031.
   
1. Insert the Male terminal into the 26 pin connector (X60001) on the PNP harness at pin 18.
2. Build Date 03/2007+, Insert female end into X6031 Pin 5 (Blue chassis side).
3. Build Pre-02/2007, Insert female end into X6031 Pin 1 (Blue chassis side).